Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Structural Standing Seam Aluminum Roof Panel Systems
Automaticky preložený názov:
Štandardné špecifikácie pre Hrubé stojatá drážka hliníkový strešný panelové systémy
NORMA vydaná dňa 10.9.1998
Označenie normy: ASTM E1637-98
Poznámka: NEPLATNÁ
Dátum vydania normy: 10.9.1998
Kód tovaru: NS-42462
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
Aluminum, Anchors/anchorage, Clips, Construction, Deflection, Endlaps, Environmental control/fate, Exposures, Fasteners, Flashings, Installation, Joints, Low-sloped roofs, Metals and metallic materials, Oil canning, Panels, Penetration, Ponding, Roofing membranes, Sealer, Service life, Side lap, Slope, Standing seam, Structural metals/alloys, Thermal, Uplift, Water, Waterproofing membranes, Weathertightness, structural standing seam aluminum roof panel systems, spec.,,Order Form
1. Scope | ||||||||||||||||||||||||||||||||||||
1.1 This specification covers the design, construction, and weatherability of structural standing seam aluminum roof panel systems that resist all superimposed design loads without the benefit of supporting deck or sheathing. It includes performance requirements for the following elements only: panels, concealed panel clips, panel/clip anchorage, and panel joint sealers. 1.2 The objective of this specification is to provide for the overall performance of the standing seam aluminum roof panel system in accordance with 1.1 during its service life in order to provide weather protection, carry the specified design loads, and allow proper access over the roof surface in order to provide periodic maintenance of the equipment by the building owner. 1.3 In addition to structural characteristics, the specifier shall evaluate other characteristics beyond the scope of this specification that affect the final choice of roof construction. These include, but are not limited to, functional, legal, insurance, and economic considerations. See Appendix X1 for the designer's checklist. 1.4 This specification is not intended to exclude products or systems not covered by the referenced documents. 1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. |
||||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||||
|
Posledná aktualizácia: 2024-07-17 (Počet položiek: 2 336 011)
© Copyright 2024 NORMSERVIS s.r.o.