Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Precision Electroformed Sieves
Automaticky preložený názov:
Štandardné špecifikácie pre jemnú Electroformed Sitá
NORMA vydaná dňa 1.5.2010
Označenie normy: ASTM E161-00(2010)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2010
Kód tovaru: NS-42346
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
opening, particle size, sieve, sieve analysis, sieve designation, sieve sheet, test sieve, Design, Electrodeposited coatings--specifications, Electroforming materials/processes, Metallic coatings--specifications, Nickel alloy coatings--specifications, Nickel coatings--specifications, Particle analysis, Precision instrumentation, Sieve analysis, Sieves, ICS Number Code 25.220.20 (Surface treatment)
1. Scope | ||||||||||
1.1 This specification covers the requirements for design and construction of electroformed sieves. These sieves are used to perform particle-size distribution analysis and in preparing narrowly designated particle-size fractions. They may also be used as reference standards when suitably calibrated. A method of calibrating these sieves is included in Annex A1. Note 1—Complete instructions and procedures on the use and calibration of testing sieves are contained in ASTM Manual 32. This publication also contains a list of all published ASTM Standards on sieve analysis procedures for specific materials or industries. 1.2 The sieve analysis results from two testing sieves of the same sieve designation may not be the same because of the variances in sieve opening permitted by this specification. To minimize the differences in sieve analysis results, the use of testing sieves matched on a performance basis is suggested. Note 2—For other types of sieves, see Specifications E11 and E323. 1.3 The values stated in SI units shall be considered standard for the dimensions of the electroformed mesh openings and the size of the wires in the electroformed mesh. The values stated in inch units shall be considered standard with regard to the sieve frames. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||
2. Referenced Documents | ||||||||||
|
Posledná aktualizácia: 2024-07-18 (Počet položiek: 2 337 971)
© Copyright 2024 NORMSERVIS s.r.o.