Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Assignment of the Glass Transition Temperature by Thermomechanical Analysis
NORMA vydaná dňa 1.4.2022
Označenie normy: ASTM E1545-22
Dátum vydania normy: 1.4.2022
Kód tovaru: NS-1054486
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
glass transition Tg, linear thermal expansion, softening point Ts, thermodilatometry, thermomechanical analysis (TMA),, ICS Number Code 81.040.01 (Glass in general)
Significance and Use | ||||||||||||
5.1?The glass transition is dependent on the thermal history of the material to be tested. For amorphous and semicrystalline materials the assignment of the glass transition temperature may lead to important information about thermal history, processing conditions, stability, progress of chemical reactions, and mechanical and electrical behavior. 5.2?Thermomechanical analysis provides a rapid means of detecting changes in hardness or linear expansion associated with the glass transition. 5.3?This test method is useful for research and development, quality control, and specification acceptance. |
||||||||||||
1. Scope | ||||||||||||
1.1?This test method describes procedures for the assignment of the glass transition temperature of materials on heating using thermomechanical measurements under compression experimental conditions. 1.2?This test method is applicable to amorphous or to partially crystalline materials that are sufficiently rigid below the glass transition to inhibit indentation by the sensing probe. 1.3?The normal operating temperature range is from ?100 ?C to 600 ?C. This temperature range may be extended depending upon the instrumentation used. 1.4?The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.