Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Radioscopic Examination of Weldments
Automaticky preložený názov:
Štandardná skúšobná metóda pre fluoroskopické vyšetrenie zvarencov
NORMA vydaná dňa 1.7.2004
Označenie normy: ASTM E1416-04
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.7.2004
Kód tovaru: NS-41688
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
gamma ray, nondestructive testing, radioscopic examination, radioscopy, weldments, x-ray, ICS Number Code 25.160.40 (Welding joints and welds)
1. Scope | ||||||||||||||||||||||||||||||||
1.1 This test method covers a uniform procedure for radioscopic examination of weldments. Requirements expressed in this test method are intended to control the quality of the radioscopic images and are not intended for controlling acceptability or quality of welds. 1.2 This test method applies only to the use of equipment for radioscopic examination in which the image is finally presented on a television monitor for operator evaluation. The examination may be recorded for later review. It does not apply to fully automated systems where evaluation is automatically performed by computer. 1.3 The radioscopic extent, the quality level, and the acceptance criteria to be applied shall be specified in the contract, purchase order, product specification, or drawings. 1.4 This test method can be used for the detection of discontinuities. This test method also facilitates the examination of a weld from several directions, such as perpendicular to the weld surface and along both weld bevel angles. The radioscopic techniques described in this test method provide adequate assurance for defect detectability; however, it is recognized that, for special applications, specific techniques using more stringent requirements may be needed to provide additional detection capability. The use of specific radioscopic techniques shall be agreed upon between purchaser and supplier. 1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in brackets are for information only. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 7. |
||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||
|
Posledná aktualizácia: 2024-08-25 (Počet položiek: 2 344 896)
© Copyright 2024 NORMSERVIS s.r.o.