Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Temperature Calibration of Thermomechanical Analyzers
Automaticky preložený názov:
Štandardná skúšobná metóda pre kalibráciu teploty termomechanických Analyzátory
NORMA vydaná dňa 1.4.2013
Označenie normy: ASTM E1363-13
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.4.2013
Kód tovaru: NS-41503
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
calibration, temperature, thermal analysis, thermomechanical analysis, ICS Number Code 17.200.20 (Temperature-measuring instruments)
Significance and Use | ||||
5.1 Thermomechanical analyzers are employed in their various modes of operation (penetration, expansion, flexure, etc.) to characterize a wide range of materials. In most cases, the value to be assigned in thermomechanical measurements is the temperature of the transition (or event) under study. Therefore, the temperature axis (abscissa) of all TMA thermal curves must be accurately calibrated either by direct reading of a temperature sensor or by adjusting the programmer temperature to match the actual temperature over the temperature range of interest. |
||||
1. Scope | ||||
1.1 This test method describes the temperature calibration of thermomechanical analyzers from − 50 to 1100°C. (See Note 1.) 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard is similar to ISO 11359–1 but addresses a larger temperature range and utilizes additional calibration materials. 1.4 This standard does not
purport to address all of the safety concerns, if any, associated
with its use. It is the responsibility of the user of this standard
to establish appropriate safety and health practices and determine
the applicability of regulatory limitations prior to use.
ISO 11359–1 Thermomechanical Analysis (TMA)-Part 1:
General Principles Standard Terminology Relating to Thermal
Analysis and Rheology (Includes all amendments and changes
10/5/2023). |
Historická
15.11.2008
Historická
1.11.2008
Historická
1.5.2009
Historická
1.5.2011
Historická
1.6.2010
Historická
1.6.2013
Posledná aktualizácia: 2024-11-24 (Počet položiek: 2 206 712)
© Copyright 2024 NORMSERVIS s.r.o.