Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM E1273-88(2019)
Standard Specification for Color Coding of Reusable Laboratory Pipets
NORMA vydaná dňa 1.7.2019
Informácie o norme:
Označenie normy: ASTM E1273-88(2019)
Dátum vydania normy: 1.7.2019
Kód tovaru: NS-967970
Počet strán: 2
Približná hmotnosť: 6 g (0.01 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM E1273-88(2019) :
This specification covers a system of color coding of reusable laboratory pipets for identification of nominal capacities and units of sub-division. This specification applies to one-mark and graduated pipets of nominal capacities. The color code and marking requirements for one-mark and graduated pipets shall take the form of color bands in accordance to the color coding system indicated in this specification.
Keywords:
colorcoding, laboratory, pipets,, ICS Number Code 01.070 (Colour coding), 71.040.20 (Laboratory ware and related apparatus)
Doplňujúce informácie
| Significance and Use | ||
|
3.1 The purpose of this specification is to ensure that if a color code is used on pipets, all manufacturers will use the same code; it is not intended as an encouragement of color coding if this is not required. |
||
| 1. Scope | ||
|
1.1 This specification covers a system of color coding for one-mark pipets for identification of nominal capacities, and for graduated pipets for identification of nominal capacities and units of sub-division. 1.2 This specification applies to one-mark and graduated pipets of the nominal capacities listed in Table 1 and Table 2, respectively. Note 1: Many pipets not covered by other ASTM standards are
included in Table 1 and
Table 2, in order, firstly,
to ensure uniformity of color coding as far as possible for
non-standard as well as standard pipets and, secondly, to reserve
suitable codes for possible future standards for other types of
pipet.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||
| 2. Referenced Documents | ||
|
Doporučujeme:
