Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Methods for Strength of Power-Actuated Fasteners Installed in Structural Members
Automaticky preložený názov:
Štandardné skúšobné metódy pre posilnenie Power-ovládaný Spojovacie inštalovaných v konštrukčných prvkoch
NORMA vydaná dňa 1.9.2011
Označenie normy: ASTM E1190-11
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.9.2011
Kód tovaru: NS-40807
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
concrete, drive pin, edge distance, failure modes, fastener, masonry, powder-actuated, power-actuated, shear test, spacing, structural member, tension test, threaded studI: Drive pin, Edge distance, Failure end point--building constructions/materials, Fasteners (structural), Fatigue, Loading tests--building constructions/materials, Masonry assemblages, Power-actuated fasteners, Shear testing--building materials, Spacing factor, Strength--construction materials/applications
Significance and Use | ||||||||
These test methods are intended to measure the anchoring capability and shear resistance of power-actuated fasteners to provide information from which applicable design values are to be derived for use in structural applications, such as in members of concrete, concrete masonry, and steel. |
||||||||
1. Scope | ||||||||
1.1 These test methods describe procedures for determining the static axial tensile and shear strengths of power-actuated fasteners installed in structural members made of concrete, concrete masonry, and steel. 1.2 These test methods are intended for use with fasteners that are installed perpendicular to a plane surface of the structural member. 1.3 Tests for combined tension and shear, fatigue, dynamic, and torsional load resistance are not covered. 1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 6. |
||||||||
2. Referenced Documents | ||||||||
|
Posledná aktualizácia: 2024-09-03 (Počet položiek: 2 346 077)
© Copyright 2024 NORMSERVIS s.r.o.