Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Guide for On-Site Inspection and Verification of Operation of Solar Domestic Hot Water Systems
Automaticky preložený názov:
Štandardné Sprievodca pre kontroly na mieste a overenie prevádzky solárnych teplej úžitkovej vody Systems
NORMA vydaná dňa 1.3.2007
Označenie normy: ASTM E1160-87(2007)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.3.2007
Kód tovaru: NS-40672
Počet strán: 7
Približná hmotnosť: 21 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
collector, controller, freeze protection, on-site inspection, solar domestic hot water system, verification of operation, ICS Number Code 27.160 (Solar energy engineering)
Significance and Use | ||||||||||||
This guide is intended for on-site assessment of in-service operation by short term measurement of appropriate system functions under representative operating conditions. Primary application is for residential systems and medium-size multi-family units or commercial buildings. Use of back-up conventional DHW heating system is assumed to augment solar heating. This guide is intended for use by suppliers, installers, consultants and homeowners in evaluating on-site operation of an installed system. Emphasis is placed on simplified measurements that do not require special skills, intrusive instrumentation, system modification or interruption of service to the purchaser. The purpose of this guide is to verify that the system is functioning. Copies of all data and reports must be submitted by the testing group to the owner or his or her designated agent. Data and reports from these procedures and tests may be used to compare the system performance over time, but should not be used to compare different systems or installations. Test is for a newly installed system and also for periodic checking. |
||||||||||||
1. Scope | ||||||||||||
1.1 This guide covers procedures and test methods for conducting an on-site inspection and acceptance test of an installed domestic hot water system (DHW) using flat plate, concentrating-type collectors or tank absorber systems. 1.2 It is intended as a simple and economical acceptance test to be performed by the system installer or an independent tester to verify that critical components of the system are functioning and to acquire baseline data reflecting overall short term system heat output. 1.3 This guide is not intended to generate accurate measurements of system performance (see ASHRAE standard 95-1981 for a laboratory test) or thermal efficiency. 1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Chcete mať istotu o platnosti využívaných predpisov?
Ponúkame Vám riešenie, aby ste mohli používať stále platné (aktuálne) legislatívne predpisy
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-09-04 (Počet položiek: 2 346 114)
© Copyright 2024 NORMSERVIS s.r.o.