Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Determining FF Floor Flatness and FL Floor Levelness Numbers [Metric]
Automaticky preložený názov:
Štandardná skúšobná metóda pre stanovenie FF Podlahové rovinnosť a FL Floor rovinnosť čísel [ Metric ]
NORMA vydaná dňa 15.1.2008
Označenie normy: ASTM E1155M-96(2008)
Poznámka: NEPLATNÁ
Dátum vydania normy: 15.1.2008
Kód tovaru: NS-40654
Počet strán: 8
Približná hmotnosť: 24 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
Ff, FF Flatness, Fl, FL Levelness, floor, floor profile, floor profilometer, F-Number, Flatness, Flooring/floor covering systems, Leveling characteristics, ICS Number Code 91.060.30 (Ceilings. Floors. Stairs)
Significance and Use | ||||
This test method provides statistical (and graphical) information concerning floor surface profiles. Results of this test method are used primarily to: Establish compliance of randomly trafficked floor surfaces with specified FF Flatness and FL Levelness tolerances, Evaluate the effect of different construction methods on resulting floor surface flatness and levelness, and Investigate the curling and deflection of floor surfaces. Results of this test method shall not be used to enforce contract flatness and levelness tolerances on those floor installations primarily intended to support the operation of fixed-path vehicle systems (for example, narrow aisle warehouse floors). Note 2—When the traffic patterns across a floor are random, (as is generally the case) evaluation of the floor's FF Flatness and FL Levelness will necessarily involve a random sampling of the surface, since all of the infinite potential profiles to be seen by the traffic can not possibly be measured. In those instances when the traffic across a floor will be confined to specific paths, however, the requirement for random sampling is eliminated, since the floor can indeed be inspected exactly as it will be seen by all of the traffic. In these special cases, rather than inferring the condition of the traffic paths from a random sample, it is far more useful to measure each of the traffic paths directly using continuous recording floor profilometer configured to run exactly in the traffic wheel paths. Such direct simulation measurements eliminate the inherent uncertainties of statistical sampling and provide profile information immediately applicable to the correction of the surface in way of the future traffic. |
||||
1. Scope | ||||
1.1 This test method covers a quantitative method of measuring floor surface profiles to obtain estimates of the floor's characteristic FF Flatness and FL Levelness Face Floor Profile Numbers (F-Numbers) using the metric (SI) system of units. Note 1—This is the metric companion to Test Method E 1155. 1.2 The text of this test method references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this test method. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Posledná aktualizácia: 2024-09-05 (Počet položiek: 2 346 132)
© Copyright 2024 NORMSERVIS s.r.o.