Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Determination of Light Hydrocarbons and Cut Point Intervals in Live Crude Oils and Condensates by Gas Chromatography (Includes all amendments And changes 2/5/2021).
Automaticky preložený názov:
Štandardná testovacia metóda na stanovenie ľahkých uhľovodíkov a odstrihnúť Point Intervaly v živej surových olejov a kondenzátoch plynovou chromatografiou
NORMA vydaná dňa 1.12.2015
Označenie normy: ASTM D8003-15a
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.12.2015
Kód tovaru: NS-630392
Počet strán: 15
Približná hmotnosť: 45 g (0.10 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
condensates, cut point interval, floating piston cylinders, light ends, light hydrocarbons, light hydrocarbon composition, live crude oil,, ICS Number Code 75.040 (Crude petroleum)
Significance and Use | ||||||||||||||||||
5.1 This test method determines methane (nC5.2 Equation of state calculations can be applied to variables provided by this method to allow for additional sample characterization. |
||||||||||||||||||
1. Scope | ||||||||||||||||||
1.1 This test method covers the determination of light hydrocarbons and cut point intervals by gas chromatography in live crude oils and condensates with VPCRNote 1: As described in Test Method D6377. 1.2 Methane (C1) to hexane (nC6) and benzene are speciated and quantitated. Samples containing mass fractions of up to 0.5 % methane, 2.0 % ethane, 10 % propane, or 15 % isobutane may be analyzed. A mass fraction with a lower limit of 0.001 % exists for these compounds. 1.3 This test method may be used for the determination of cut point carbon fraction intervals (see 3.1.2) of live crude oils and condensates from initial boiling point (IBP) to 391 °C (nC1.4 Dead oils or condensates sampled in accordance with 12.1 may also be analyzed. 1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5.1 Exception—Where there is no direct SI equivalent such as tubing size. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||
|
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-05-13 (Počet položiek: 2 898 634)
© Copyright 2024 NORMSERVIS s.r.o.