ASTM D7938-21

5.1?This practice was developed5.1.1?For many years ¹⁴C was not included in gaseous and liquid effluent measurements used for effluent dose calculations at nuclear power facilities. U.S. NRC Regulatory Guide 1.21 now requires ¹⁴C analysis (either estimated by calculation or actual measurement) and its impact on annual dose in the environs of nuclear plants be evaluated. Based on the revisions to the Regulatory Guide and NRC guidance to licensees, ¹⁴C activity will need to be reported and evaluated for dose contribution based on the activity concentration and chemical form of the ¹⁴C in the release.

5.2?While ¹⁴C releases may be estimated, the measurement of actual ¹⁴C emissions provides a more reliable and accurate means of reporting emissions. The chemical form of ¹⁴C that yields the greatest dose significance due to uptake by living organisms is the inorganic form. Thus the distribution of ¹⁴C chemical forms in plant effluents is important in assessing the overall dose impact.

5.3?Use of this sampling practice has identified that for pressurized water reactors (PWRs) >90 % of all ¹⁴C released may be in the 5.3.1?Some power plants have catalytic hydrogen recombiners in the waste gas processing system. These can also oxidize organic carbon to CO₂, increasing the percentage of ¹⁴CO_{5.3.2?During refueling outages, oxidizing conditions exist in the reactor cavity due to air saturation and radiolytic reactions by the nuclear fuel. The combination of these two effects has been shown to increase the ¹⁴CO5.4?The sampling methodology described in this practice is not capable of discriminating between different organic forms of ¹⁴C.}

1.1?The intended use of this practice is for sampling of gasses containing ¹⁴C in inorganic, organic or particulate forms. This sampling practice captures the ¹⁴C in a media that can be submitted to a laboratory for analysis, typically by liquid scintillation counting (LSC)

1.2?This practice does not include the needed steps for the liberation of ¹⁴C from the media on which it was adsorbed or those for the preparation for LSC sample preparation in the laboratory prior to liquid scintillation analysis. This practice does not include the methodology used to analyze the prepared samples by LSC.

1.3?The overall ¹⁴C analytical detection capability is impacted by a number of factors including the volume sampled, the method used to desorb the ¹⁴C from the media, and the analytical method used the measure ¹⁴C from the media. This practice only directly addresses the volume of the gas stream from which any present ¹⁴C would be adsorbed.

1.4?The values stated in pCi units are to be regarded as standard given the reporting requirements of the U.S. NRC Regulatory Guide 1.21. The Bq values given in parenthesis are mathematical conversions to SI units that are provided for information only and are not considered standard. Other values stated in SI units are to be regarded as standard.

1.5?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.