Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Molding Index of Thermosetting Molding Powder
Automaticky preložený názov:
Štandardná skúšobná metóda pre formovanie indexu tvrditeľný lisovacie Prášok
NORMA vydaná dňa 1.5.2010
Označenie normy: ASTM D731-10
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2010
Kód tovaru: NS-38130
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
molding index, plasticity, thermosets, Molding index, Thermosetting materials/properties, Thermosetting plastics, ICS Number Code 83.080.10 (Thermosetting materials)
Significance and Use | ||||||||
This test method provides a guide for evaluating the moldability of thermosetting molding powders. This test method does not necessarily denote that the molding behavior of different materials will be alike and trials may be necessary to establish the appropriate molding index for each material in question. The sensitivity of this test diminishes when the molding pressure is decreased below 5.3 MPa (764 psi), so pressures lower than this are not ordinarily recommended. This is due to the friction of moving parts and the insensitivity of the pressure switch actuating the timer at these low pressures. |
||||||||
1. Scope | ||||||||
1.1 This test method covers the measurement of the molding index (plasticity) of thermosetting plastics ranging in flow from soft to stiff by selection of appropriate molding pressures within the range from 3.7 to 36.5 MPa (530 to 5300 psi). 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1—There is no known ISO equivalent to this test method. |
||||||||
2. Referenced Documents | ||||||||
|
Historická
1.3.2004
Historická
1.7.2010
Historická
1.9.2009
Historická
1.11.2012
Historická
1.2.2011
Historická
1.2.2009
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2025-02-12 (Počet položiek: 2 224 918)
© Copyright 2025 NORMSERVIS s.r.o.