Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Guide for Prediction of Analyzer Sample System Lag Times
Automaticky preložený názov:
Štandardné Príručka pre predikciu Analyzer Ukážka systému Lag Times
NORMA vydaná dňa 1.4.2016
Označenie normy: ASTM D7278-16
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.4.2016
Kód tovaru: NS-637683
Počet strán: 9
Približná hmotnosť: 27 g (0.06 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
analyzer, lag time, on-line, sample systems, sampling, response,, ICS Number Code 17.220.01 (Electricity. Magnetism. General aspects)
Significance and Use | ||||
5.1 The analyzer sample system lag time estimated by this guide can be used in conjunction with the analyzer output to aid in optimizing control of blender facilities or process units. 5.2 The lag time can be used in the tuning of control programs to set the proper optimization frequency. 5.3 The application of this guide is not for the design of a sample system but to help understand the design and to estimate the performance of existing sample systems. Additional detailed information can be found in the references provided in the section entitled Additional Reading Material. |
||||
1. Scope | ||||
1.1 This guide covers the application of routine calculations to estimate sample system lag time, in seconds, for gas, liquid, and mixed phase systems. 1.2 This guide considers the sources of lag time from the process sample tap, tap conditioning, sample transport, pre-analysis conditioning and analysis. 1.3 Lag times are estimated based on a prediction of flow characteristics, turbulent, non turbulent, or laminar, and the corresponding purge requirements. 1.4 Mixed phase systems prevent reliable representative sampling so system lag times should not be used to predict sample representation of the stream. 1.5 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-04-26 (Počet položiek: 2 896 057)
© Copyright 2024 NORMSERVIS s.r.o.