Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Guide for Calibration Facility Setup for Nuclear Surface Gauges
Automaticky preložený názov:
Štandardné príručka pre kalibráciu Facility nastavenie pre jadrové Surface meradiel
NORMA vydaná dňa 15.2.2011
Označenie normy: ASTM D7013/D7013M-11
Poznámka: NEPLATNÁ
Dátum vydania normy: 15.2.2011
Kód tovaru: NS-37297
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
calibration, calibration block, calibration facility, calibration reference block, gauge, nuclear gauge, Density gauge calibration, Nuclear surface moisture, ICS Number Code 27.120.10 (Reactor engineering)
Significance and Use | ||||||||
To establish a proper calibration area for nuclear surface gauges. To reduce the chance of improper calibration. Note 1—The quality of the results produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. Agencies that meet the criteria of practice D3740 are generally considered capable of competent and objective testing/inspection/etc. Users of this standard are cautioned that compliance with practice D3740 does not in itself assure a means of evaluating some of those factors. |
||||||||
1. Scope | ||||||||
1.1 This guide outlines procedures for setup of a nuclear gauge calibration facility in either a shielded bay or an unshielded areaGuide A and Guide B, respectively. 1.2 This guide does not attempt to describe the calibration techniques or methods. It is assumed that this guide will be used by persons familiar with the operations of the gauge and in performing proper calibration, service and maintenance. 1.3 This guide does not attempt to address maintenance or service procedures related to the gauge. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.5 This guide does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this guide to establish appropriate safety, and health practices and determine the applicability of regulatory limitations prior to use. 1.6 This guide offers an organized collection of information or a series of options and does not recommend a specific course of action. This document cannot replace education or experience and should be used in conjunction with professional judgment. Not all aspects of this guide may be applicable in all circumstances. This ASTM standard is not intended to represent or replace the standard of care by which the adequacy of a given professional service must be judged, nor should this document be applied without consideration of a project’s many unique aspects. The word “Standard” in the title of this document has been approved through ASTM consensus process. 1.7 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in practice D6026. 1.7.1 The method used to specify how data are collected, calculated, or recorded in this standard is not directly related to the accuracy to which the data can be applied in the design or other uses, or both. How one applies the results obtained using this standard is beyond its scope. |
||||||||
2. Referenced Documents | ||||||||
|
Posledná aktualizácia: 2024-12-23 (Počet položiek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.