Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Guide for Determination of Thickness of Plastic Film Test Specimens
Automaticky preložený názov:
Štandardné vodítko pre stanovenie hrúbky plastovej fólie skúšobných vzoriek
NORMA vydaná dňa 1.4.2013
Označenie normy: ASTM D6988-13
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.4.2013
Kód tovaru: NS-37228
Počet strán: 7
Približná hmotnosť: 21 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
dial gauge, dimensions, film, plastics, thickness, ICS Number Code 83.140.10 (Films and sheets)
Significance and Use | ||||||||||
5.1 This guide is intended to provide recommendations and suggested good practices to determine precise dimensions when necessary for the calculation of properties expressed in physical units. It is not intended to replace practical thickness measurements based on commercial portable tools, nor is it implied that thickness measurements made by the procedures will agree exactly. |
||||||||||
1. Scope | ||||||||||
1.1 This guide covers the determination of the thickness of plastic films where the thickness is used directly in determining the results of tests for various properties. Use this practice except as otherwise required in material specifications or in applicable test standards. 1.2 The values stated in SI units
are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.
|
|
Standard Practice for Cutting Film and Sheeting Test Specimens
|
ISO 472
|
Plastics--Vocabulary Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036.
|
|
Standard Practice for Conditioning Plastics for Testing
|
|
Standard Terminology Relating to Plastics
|
|
Standard Test Methods for Physical Dimensions of Solid Plastics Specimens |
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.