Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Measuring the Effect on Filterability of Engine Oils After Treatment with Various Amounts of Water and a Long(6 h) Heating Time
Automaticky preložený názov:
Štandardná skúšobná metóda na meranie efektu na filtrovateľnosť oleja motora po ošetrení s rôznym množstvom vody a Long (6 h) Doba ohrevu
NORMA vydaná dňa 1.5.2014
Označenie normy: ASTM D6794-14
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2014
Kód tovaru: NS-36566
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
engine lubricating oil, filterability, storage, ICS Number Code 75.100 (Lubricants, industrial oils and related products)
Significance and Use | ||||||||||
5.1 It is normal for some of the combustion products of an internal combustion engine to penetrate into the engine lubricant and be retained in it. 5.2 When an engine is run for a period of time and then stored over a long period of time, the by-products of combustion might be retained in the oil in a liquefied state. 5.3 Under these circumstances, precipitates can form that impair the filterability of the oil the next time the engine is run. 5.4 This test method subjects the test oil and the new oil to the same treatments such that the loss of filterability can be determined. 5.5 Reference oils, on which the data obtained by this test method is known, are available. 5.6 This test method requires that a reference oil also be tested and results reported. Two oils are available, one known to give a low and one known to give a high data value for this test method. 1.1 This test method covers the
determination of the tendency of an oil to form a precipitate that
can plug an oil filter. It simulates a problem that may be
encountered in a new engine run for a short period of time,
followed by a long period of storage with some water in the
oil.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||
2. Referenced Documents | ||||||||||
|
Historická
1.7.2011
Historická
1.12.2012
Historická
1.6.2012
Historická
1.12.2012
Historická
1.12.2012
Historická
1.5.2013
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.