Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Automated Heithaus Titrimetry
Automaticky preložený názov:
Štandardná skúšobná metóda pre automatické Heithaus titráciou
NORMA vydaná dňa 1.6.2014
Označenie normy: ASTM D6703-14
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.6.2014
Kód tovaru: NS-36200
Počet strán: 9
Približná hmotnosť: 27 g (0.06 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
asphalt, bitumen, coke, colloidal stability, compatibility, heavy oil residua, ICS Number Code 17.060 (Measurement of volume, mass, density, viscosity)
Significance and Use | ||||||||||
5.1 This test method is intended primarily as a laboratory diagnostic tool for estimating the colloidal stability of bitumen asphalt, asphalt cross blends, aged asphalt, and heavy oil residuum. Historically, bituminous asphalt and heavy oil residua have been modeled as colloidal suspensions in which a polar associated asphaltene moiety (the dispersed phase) is suspended in a maltene solvent moiety (the dispersing medium) (refer to Test Methods D3279, D4124, and D5546 for further definition of asphalt fraction materials). The extent to which these two moieties remain in state of peptization is a measure of the compatibility (colloidal stability) of the suspension. Compatibility influences the physical properties of these materials, including rheological properties, for example, phase angle and viscosity. This test method and other similar test methods, along with the classical Heithaus test, measures the overall compatibility of a colloidal system by determining a parameter referred to as the state of peptization, 1.1 This test method describes a procedure for quantifying three Heithaus compatibility parameters that quantify the colloidal stability of asphalts and asphalt cross blends and aged asphalts. 1.2 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||
2. Referenced Documents | ||||||||||
|
Historická
1.6.2014
Historická
1.10.2010
Historická
15.10.2011
Historická
1.7.2010
Historická
1.4.2008
Historická
1.7.2014
Poskytovanie aktuálnych informácií o legislatívnych predpisoch vyhlásených v Zbierke zákonov od roku 1945.
Aktualizácia 2x v mesiaci !
Chcete vedieť viac informácii ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.