Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Viscosity and Yield of Vehicles and Varnishes by the Duke Viscometer
Automaticky preložený názov:
Štandardná skúšobná metóda pre Viskozita a výnos vozidiel a lakov, ktoré Duke viskozimetra
NORMA vydaná dňa 1.12.2010
Označenie normy: ASTM D6606-00(2010)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.12.2010
Kód tovaru: NS-35850
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Měření objemu, hmotnosti, hustoty, viskozity
Nátěrové hmoty, barvy a laky
Keywords:
apparent viscosity, automated viscometers, falling-rod viscometers, non-Newtonian, power law model, rod and collar viscometers, shortness, vehicles, viscometers, viscosity, yield value, Duke viscometer, Viscometers, Viscosity--paints/related coatings/materials, ICS Number Code 17.060 (Measurement of volume, mass, density, viscosity), 87.040 (Paints and varnishes)
Significance and Use | ||
Actual direct measurements of apparent viscosity and stress at shear rates of interest can be useful in the practical control of ink viscosity during production and the specification acceptance between supplier and purchaser. Use of the Duke automated viscometer provides direct measurements for viscosity and yield value versus extrapolating data points that may be far from the desired shear rates. |
||
1. Scope | ||
1.1 This test method covers the procedure for determining the viscosity of varnishes, ink vehicles, and similar liquids that are essentially nonvolatile and unreactive under ordinary room conditions using the Duke Automated high-shear rod and collar viscometer. 1.2 The instrument in this test method is similar in principle to the falling-rod viscometer described in Test Method D4040 except that the collar is motor driven and the range of available shear stresses is considerably greater. This instrument is capable of measured and extrapolated viscosity and yield values provided the proper model is chosen for the given application. See Section 6 for the ranges of specified models. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, that may be associated with its use. It is the responsibility of the user of this standard to establish any appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
2. Referenced Documents | ||
|
Historická
1.12.2010
Historická
1.11.2012
Historická
1.11.2012
Historická
1.11.2012
Historická
1.2.2013
Historická
1.10.2010
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.