Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Determination of pHe of Ethanol, Denatured Fuel Ethanol, and Fuel Ethanol (Ed75-Ed85)
Automaticky preložený názov:
Štandardná testovacia metóda pre stanovenie RP etanolu , denaturovaného etanolu palivové a etanolu palivovej ( ED75 - Ed85 )
NORMA vydaná dňa 15.12.2008
Označenie normy: ASTM D6423-08
Poznámka: NEPLATNÁ
Dátum vydania normy: 15.12.2008
Kód tovaru: NS-35085
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
acid strength, automotive spark ignition engine fuel, corrosion potential, denatured fuel ethanol, ethanol, fuel ethanol, pHe, Denatured fuel ethanol, Ethanol, Fuel ethanol (Ed75-Ed85), pH, ICS Number Code 27.060.10 (Liquid and solid fuel burners)
Significance and Use | ||||||||
The acid strength, as measured by pHe, is a good predictor of the corrosion potential of ethanol fuels. It is preferable to total acidity because total acidity does not measure acid strength; overestimates the contribution of weak acids, such as carbonic acid; and may underestimate the corrosion potential of low concentrations of strong acids, such as sulfuric acid. |
||||||||
1. Scope | ||||||||
1.1 This test method covers a procedure to determine a measure of the acid strength of high ethanol content fuels. These include ethanol, denatured fuel ethanol, and fuel ethanol (Ed75-Ed85). The test method is applicable to fuels containing nominally 70 volume % ethanol, or higher, as described in Specifications D 4806 and D 5798. 1.2 Acid strength as measured in this test method is defined as pHe. A pHe value for alcohol solutions is not comparable to pH values of water solutions. For example, a 1.5×10-5 M (18 ppm) solution of H2SO4 gives a pH of about 5.5 in water solution, but, depending on buffering strength, a pHe as low as 1 to 2 in unadditized alcohol fuel. 1.3 The value of pHe measured will depend somewhat on the fuel blend, the stirring rate, and the time the electrode is in the fuel. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||
2. Referenced Documents | ||||||||
|
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.