Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Methods for Single Filament Hose Reinforcing Wire Made from Steel (Withdrawn 2023)
Automaticky preložený názov:
Štandardné skúšobné metódy pre jednoduché nite hadice Posilnenie drôt vyrobený z ocele
NORMA vydaná dňa 15.5.2014
Označenie normy: ASTM D6320/D6320M-10(2014)
Poznámka: NEPLATNÁ
Dátum vydania normy: 15.5.2014
Kód tovaru: NS-34658
Počet strán: 9
Približná hmotnosť: 27 g (0.06 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
diameter, elongation, reverse bend, strength, breaking, strength, knot, torsion, wire, hose reinforcing, wrap, ICS Number Code 77.140.65 (Steel wire, wir ropes and link chains)
Significance and Use | |||||||||||||||||||||||||||||||||
5.1 The procedures for the determination of properties of single-filament hose reinforcing wire made from steel are considered satisfactory for acceptance testing of commercial shipments of this product because the procedures are the best available and have been used extensively in the trade. 5.1.1 In the case of a dispute arising from differences in reported test results when using these test methods for acceptance testing of commercial shipments, the purchaser and supplier should conduct comparative tests to determine if there is a statistical bias between their laboratories. Competent statistical assistance is recommended for investigation of bias. As a minimum, two parties should take a group of test specimens which are as homogeneous as possible and which are from a lot of material of the type in question. The test specimens then should be randomly assigned in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared by using an appropriate statistical test and an acceptable probability level chosen by the two parties before testing is begun. If a bias is found, either its cause must be determined and corrected or the purchaser and supplier must agree to interpret future test results with consideration to the known bias. |
|||||||||||||||||||||||||||||||||
1. Scope | |||||||||||||||||||||||||||||||||
1.1 These test methods cover testing of single filament steel wires that are used to reinforce hose products. By agreement, these test methods may be applied to similar filaments used for reinforcing other rubber products. 1.2 These test methods describe test procedures only and do not establish specifications or tolerances. 1.3 These test methods cover the determinations of the mechanical properties listed below:
Podobné normy: Historická Historická Historická Historická Historická Historická Odporúčame:Aktualizácia technických noriem
Chcete mať istotu, že používate len platné technické normy? Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568) |