Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Trace Benzene in Hydrocarbon Solvents by Capillary Gas Chromatography
Automaticky preložený názov:
Štandardná skúšobná metóda pre Trace benzénu v uhľovodíkových rozpúšťadlách pomocou kapilárnej plynovej chromatografie
NORMA vydaná dňa 1.12.2010
Označenie normy: ASTM D6229-06(2010)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.12.2010
Kód tovaru: NS-34306
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Fyzikálně chemické analytické metody
Ostatní organické chemikálie
Keywords:
benzene content, capillary GC, gas chromatography, hydrocarbon solvents, Benzene--paints/related coatings/materials, Capillary gas chromatography, Gas chromatography (GC)--paints/related coatings/materials, Hydrocarbon solvents, Trace elements--paints/related coatings/materials, ICS Number Code 71.040.50 (Physicochemical methods of analysis), 71.080.99 (Other organic chemicals)
Significance and Use | ||||||
This test method is similar to Test Method D4367 with the exception that capillary columns are used and intended for trace level of benzene in hydrocarbon solvents. The need for trace benzene analysis in hydrocarbon solvents arose because of the increase of more stringent regulation of benzene level in these materials. |
||||||
1. Scope | ||||||
1.1 This test method covers the determination by capillary gas chromatography of trace benzene in hydrocarbon solvents at levels from 1.0 to 2400 vppm. Note 1—Lower levels of benzene may be determined by this test method. However the gas chromatography (GC) will have to be modified from those specified in this test method. The precision of the method may not apply to these lower benzene levels. 1.2 For hazard information and guidance, see the supplier's Material Safety Data Sheet. 1.3 The values stated in SI units are to be regarded as the statement. The values in parenthesis are given for information only and are not necessarily the exact equivalent of the SI unit values. 1.4 For purposes of determining conformance of an observed or a calculated value using this test method to relevant specifications, test result(s) shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with Practice E29. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||
2. Referenced Documents | ||||||
|
Posledná aktualizácia: 2024-11-04 (Počet položiek: 2 209 323)
© Copyright 2024 NORMSERVIS s.r.o.