Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D6073-96(2001)
Standard Test Method for Relative Setting of Heatset Printing Inks by the Sinvatrol Tester
Automaticky preložený názov:
Štandardná skúšobná metóda pre Relatívna Nastavenie Heatset tlačových farieb u Sinvatrol Tester
NORMA vydaná dňa 1.1.2001
Informácie o norme:
Označenie normy: ASTM D6073-96(2001)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.1.2001
Kód tovaru: NS-33656
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM D6073-96(2001) :
Keywords:
heat-set printing inks, printing apparatus, setting speed, tester, ICS Number Code 87.080 (Inks. Printing inks)
Doplňujúce informácie
| 1. Scope | ||
|
1.1 This test method describes the procedure for determining the relative setting speed of heatset inks using a specific tester. 1.2 this test method is applicable to printing inks intended to be dried by the application of heat and for which a suitable reference standard is available. 1.3 Although heatset inks are normally printed by the offset process, this test method specifies the direct letterpress mode because the higher ink film thicknesses obtained tend to amplify subtle differences in ink setting speed. 1.4 This tester reads temperature and belt speed in nonmetric terms; therefore, instrument settings in this test method are stated first in U.S. Customary Units (inch-pound units of measurements). The values given in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
| 2. Referenced Documents | ||
|
Doporučujeme:
