Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Determination of the Impact Value (IV) of a Soil
Automaticky preložený názov:
Štandardná skúšobná metóda pre stanovenie hodnoty vplyvov (IV) o pôde
NORMA vydaná dňa 1.5.2007
Označenie normy: ASTM D5874-02(2007)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2007
Kód tovaru: NS-32908
Počet strán: 9
Približná hmotnosť: 27 g (0.06 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
acceptance test, clegg impact value, compaction control, impact soil test, impact test, impact test hammer, impact value, light impact value, soil test, stabilization testing, strength test, trench testing, turf testing, ICS Number Code 13.080.20 (Physical properties of soil)
1. Scope | ||||||||||||||||||||||||||
1.1 This test method covers the determination of the Impact Value (IV) of a soil either in the field or a test mold. 1.2 The standard test method, using a 4.5 kg (10 lbm) hammer, is suitable for, but not limited to, evaluating the strength of an unsaturated compacted fill, in particular pavement materials, soils, and soil-aggregates having maximum particle sizes less than 37.5 mm (1.5 in.). 1.3 By using a lighter 0.5 kg (1.1 lbm) hammer, this test method is applicable for evaluating lower strength soils such as fine grained cohesion less, highly organic, saturated, or highly plastic soils having a maximum particle size less than 9.5 mm (0.375 in.). 1.4 By performing laboratory test correlations for a particular soil using the 4.5 kg (10 lbm) hammer, IV may be correlated with an unsoaked California Bearing Ratio (CBR) or may be used to infer percentage compaction. 1.5 The values stated SI are to be regarded as the standard. The values stated in parentheses are given for information only. 1.6 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D 6026. The method used to specify how data are collected, calculated, or recorded in this standard is not directly related to the accuracy to which the data can be applied in design or other uses or both. How one applies the results obtained using this standard is beyond its scope. 1.7 This standard may involve hazardous materials, operations, and equipment This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1The equipment and procedures contained in this test method are similar to those developed by B. Clegg in the 1970s at the University of Western Australia, Nedlands, Australia. Impact Value is also commonly known as Clegg Impact Value (CIV). |
||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||
|
Posledná aktualizácia: 2024-11-01 (Počet položiek: 2 208 817)
© Copyright 2024 NORMSERVIS s.r.o.