Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Rubber-Determination of Residual Unsaturation in Hydrogenated Nitrile Rubber (HNBR) by Infrared Spectrophotometry
Automaticky preložený názov:
Štandardná skúšobná metóda pre gumový stanovenie reziduálne nenasýtené väzby hydrogenizované nitrilovej gumy ( HNBR ) , infračervenú Spektrofotometria
NORMA vydaná dňa 1.7.2009
Označenie normy: ASTM D5670-95(2009)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.7.2009
Kód tovaru: NS-32113
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
HNBR, hydrogenated nitrile rubber, infrared spectrometry (IR), unsaturation, Chemical analysis--rubber chemicals/materials, HNBR (hydrogenated nitrile rubber), Infrared spectrophotometry, Nitrile rubber, Residual unsaturation, Rubber, Unsaturation, ICS Number Code 83.060 (Rubber)
Significance and Use | ||||||
Hydrogenated nitrile rubbers are available at different levels of unsaturation and different acrylonitrile content. Highly saturated grades offer optimum resistance to aging, such as exposure to heat, ozone, and chemicals, and can be effectively cured only with peroxides or high energy radiation. Partially unsaturated grades can be cured by sulfur systems in addition to peroxides and high energy radiation. This test method provides an infrared technique to determine the unsaturation level of hydrogenated nitrile rubbers in the raw state. It can be used for research and development, quality control, and referee purposes. |
||||||
1. Scope | ||||||
1.1 This test method covers the percentage of residual unsaturation (double bonds in unhydrogenated butadiene) in hydrogenated nitrile rubber and is based on infrared examination of rubber films cast from solution. 1.2 This test method is applicable to all grades of hydrogenated nitrile rubber in the raw state. 1.3 This test method assumes that specimens and infrared spectra are prepared and analyzed by experienced personnel and that the equipment is operated according to the manufacturer's direction for optimum performance. No details for operation of infrared spectrophotometers are included in this test method. 1.4 Since it is customary in infrared spectrophotometry to use wavenumbers (cm−1) rather than Hertz (Hz), the unit for frequency in the SI system, the former is employed throughout this test method. 1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||
2. Referenced Documents | ||||||
|
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-11-21 (Počet položiek: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.