Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Methods for Heat Resistance of Polymer Linings for Flue Gas Desulfurization Systems
NORMA vydaná dňa 1.2.2021
Označenie normy: ASTM D5499-94(2021)
Dátum vydania normy: 1.2.2021
Kód tovaru: NS-1019305
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
adhesion, blistering, cracking, flue gas desulfurization, heat resistance, polymer linings, thermal effects,, ICS Number Code 83.080.20 (Thermoplastic materials)
Significance and Use | ||||||||||||||||||||||
3.1?The results obtained by these test methods can be used in combination with other test methods for the selection of a lining in flue gas desulfurization (FGD) systems. 3.2?These methods are intended to evaluate effects of heat alone upon a lining system as applied to a carbon steel substrate. These methods do not produce the thermal gradient that may exist in actual applications. Actual lining performance may also be effected by concurrent physical mechanical or chemical effects. 3.3?These methods evaluate major failure modes of linings applied to square test panels. 3.4?The recommended test temperatures of 200?F (93?C) and 350?F (177?C) are based on typical maximum operating zone temperatures in flue gas desulfurizations systems. Other temperatures may be evaluated as desired. |
||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||
1.1?These test methods are intended to evaluate the resistance of polymer linings applied to carbon steel substrates to elevated temperatures. Two separate methods are included as follows: 1.1.1?Test Method A Continuous elevated temperature exposure, and 1.1.2?Test Method B Cycling elevated temperature exposure. 1.2?The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||
|
Chcete mať istotu o platnosti využívaných predpisov?
Ponúkame Vám riešenie, aby ste mohli používať stále platné (aktuálne) legislatívne predpisy
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-05-17 (Počet položiek: 2 902 148)
© Copyright 2024 NORMSERVIS s.r.o.