Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D5483-05(2010)
Standard Test Method for Oxidation Induction Time of Lubricating Greases by Pressure Differential Scanning Calorimetry
Automaticky preložený názov:
Štandardná skúšobná metóda pre oxidáciu indukčnej doby mazivá od tlaku diferenčný skenovací kalorimetria
NORMA vydaná dňa 1.10.2010
Informácie o norme:
Označenie normy: ASTM D5483-05(2010)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.10.2010
Kód tovaru: NS-31398
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM D5483-05(2010) :
Keywords:
differential scanning calorimetry, lubricating grease, OIT, onset temperature, oxidation, oxidation coefficient, oxidation induction time, PDSC, thermal analysis, Differential scanning calorimetry (DSC), Lubricating grease, Oxidation induction time (OIT), Oxidation testing--petroleum products, PDSC (pressure differential scanning calorimetry), Pressure differential scanning calorimetry (PDSC), Thermal analysis (TA)--petroleum products
Doplňujúce informácie
| Significance and Use | ||
|
Oxidation induction time, as determined under the conditions of this test method, can be used as an indication of oxidation stability. This test method can be used for research and development, quality control and specification purposes. However, no correlation has been determined between the results of this test method and service performance. |
||
| 1. Scope | ||
|
1.1 This test method covers the determination of oxidation induction time of lubricating greases subjected to oxygen at 3.5 MPa (500 psig) and temperatures between 155 and 210°C. 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
| 2. Referenced Documents | ||
|
Doporučujeme:
