Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D5478-09
Standard Test Methods for Viscosity of Materials by a Falling Needle Viscometer
Automaticky preložený názov:
Štandardné testovacie metódy pre Viskozita materiálov padajúce Needle viskozimetra
NORMA vydaná dňa 1.2.2009
Informácie o norme:
Označenie normy: ASTM D5478-09
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.2.2009
Kód tovaru: NS-31376
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM D5478-09 :
Keywords:
falling needle viscometer, Newtonian fluid, non-Newtonian fluid, rheological property, rheometer, viscometer, viscosity, yield stress, Viscometers--falling needle, Viscosity--paints/related coatings/materials, Falling needle viscometer, Newtonian fluids, Non-Newtonian fluids, Paint testing, Rheology/rheological properties, Varnishes, Yield stress, ICS Number Code 17.060 (Measurement of volume, mass, density, viscosity)
Doplňujúce informácie
| Significance and Use | ||||
|
These test methods are applicable for measuring the rheological properties of varnishes and paints. In particular, the low to moderate shear rate measurements provide information related to sag resistance, leveling, etc. |
||||
| 1. Scope | ||||
|
1.1 These test methods cover the measurement of the viscosity of Newtonian and non-Newtonian liquids. These test methods are applicable to liquids having viscosities in the range from 5 × 10−4 to 103 Pa·s (0.5 to 106 cP). The shear rate range is dependent upon the needle used and viscosity of the liquid and may vary from 10−4 to 103 s−1. 1.2 The yield stress of liquids having this property may also be determined. 1.3 These test methods consist of determining liquid viscosities of Newtonian and non-Newtonian fluids (clear or opaque) by measuring the steady-state (constant) or terminal velocities of cylindrical needles as they fall through the test liquid under the influence of gravity. Yield stresses of non-Newtonian liquids may be measured using the same procedure. 1.4 The values stated in SI units are to be regarded as standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
| 2. Referenced Documents | ||||
|
Odporúčame:
Aktualizácia technických noriem
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
