Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D5423-93(2005)
Standard Specification for Forced-Convection Laboratory Ovens for Evaluation of Electrical Insulation (Withdrawn 2014)
Automaticky preložený názov:
Štandardné špecifikácie pre nútené horúci Laboratórne pece pre hodnotenie elektrickej izolácie ( Withdrawn 2014 )
NORMA vydaná dňa 1.9.2005
Informácie o norme:
Označenie normy: ASTM D5423-93(2005)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.9.2005
Kód tovaru: NS-31119
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM D5423-93(2005) :
Keywords:
forced-convection, ovens, set temperature, temperature fluctuation, temperature gradient, thermal endurance evaluation, thermal lag time, ventilated, ventilation rate, ICS Number Code 71.040.10 (Chemical laboratories. Laboratory equipment)
Doplňujúce informácie
| 1. Scope | ||||||
|
1.1 This specification covers forced-convection ventilated electrically-heated ovens, operating over all or part of the temperature range from 20C above the ambient temperature to 500C, and used for thermal endurance evaluation of electrical insulating materials. 1.2 The specification requirements for Type I ovens are based on IEC Publication 216-4-1, and are technically identical to it. The requirements for Type II ovens are essentially identical to the requirements of Specification D 2436. This specification and an associated test method, D5374, have replaced Specification D 2436. 1.3 While the ovens covered by this specification are intended primarily for thermal endurance evaluation, they can also be used wherever their characteristics make them suitable for other applications. 1.4 This specification does not address safety aspects. If it is anticipated that oven contents or the location in which the oven is to be installed may create a hazard, the purchaser should determine and specify what additional requirements are needed. |
||||||
| 2. Referenced Documents | ||||||
|
Doporučujeme:
