Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Methods for Volatile Content of Radiation Curable Materials
NORMA vydaná dňa 1.7.2021
Označenie normy: ASTM D5403-93(2021)
Dátum vydania normy: 1.7.2021
Kód tovaru: NS-1031883
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
electron beam curing, radiation curable material, radiation curing, ultraviolet curing, volatile content,, ICS Number Code 13.280 (Radiation protection)
Significance and Use | ||||||||
5.1?These test methods are the procedures of choice for determining volatile content of materials designed to be cured by exposure to ultraviolet light or electron beam irradiation. These types of materials contain liquid reactants that react to become part of the film during cure, but, which under the test conditions of Test Method D2369, will be erroneously measured as volatiles. The conditions of these test methods are similar to Test Method D2369 with the inclusion of a step to cure the material prior to weight loss determination. Volatile content is determined as two separate componentsprocessing volatiles and potential volatiles. Processing volatiles is a measure of volatile loss during the actual cure process. Potential volatiles is a measure of volatile loss that might occur during aging or under extreme storage conditions. These volatile content measurements are useful to the producer and user of a material and to environmental interests for determining emissions. |
||||||||
1. Scope | ||||||||
1.1?These test methods cover procedures for the determination of weight percent volatile content of coatings, inks, and adhesives designed to be cured by exposure to ultraviolet light or to a beam of accelerated electrons. 1.2?Test Method A is applicable to radiation curable materials that are essentially 100 % reactive but may contain traces (no more than 3 %) of volatile materials as impurities or introduced by the inclusion of various additives. 1.3?Test Method B is applicable to all radiation curable materials but must be used for materials that contain volatile solvents intentionally introduced to control application viscosity and which are intended to be removed from the material prior to cure. 1.4?These test methods may not be applicable to radiation curable materials wherein the volatile material is water, and other procedures may be substituted by mutual consent of the producer and user. 1.5?The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.6?This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||
2. Referenced Documents | ||||||||
|
Chcete mať istotu o platnosti využívaných predpisov?
Ponúkame Vám riešenie, aby ste mohli používať stále platné (aktuálne) legislatívne predpisy
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.