ASTM D5373-02(2007)

Carbon and hydrogen values are used to determine the amount of oxygen (air) required in combustion processes and for the calculations of efficiency of combustion processes.

Carbon and hydrogen determinations are used in material balance calculations on coal conversion processes; also, one or the other is used frequently in correlations of chemical and physical properties, such as yields of products in liquefaction reactivity in gasification and the density and porosity of coal.

Nitrogen data are required to fulfill the requirements of the ultimate analysis, Practice D 3176. Also, the data obtained can be used to evaluate the potential formation of nitrogen oxides as a source of atmospheric pollution.

Nitrogen data are used for comparing coals and in research. If the oxygen content of coal is estimated by difference, it is necessary to make a nitrogen determination.

1.1 These test methods cover the instrumental determination of carbon, hydrogen, and nitrogen in laboratory samples of coal and coke prepared in accordance with Test Methods D 2013 and D 346.

1.2 Within the limitations outlined below, these test methods are applicable to either the air-dry or moisture-free laboratory sample, or both.

1.2.1 For instrumental systems in which the moisture and waters of hydration in the sample are liberated with (and only with) the oxidation products upon combustion, the analyses can be performed on a test specimen of the air-dry sample (Note 1). Concentrations determined on this air-dried basis represent the total carbon (including that present as carbonate), total hydrogen (including that present as water), and total nitrogen.

Note 1—These systems are also satisfactory for determining the subject materials in the moisture-free sample.

1.2.2 For systems in which the moisture and hydrates are otherwise liberated, the analysis shall be performed on the moisture-free sample. Values obtained on this basis represent the total carbon, organic hydrogen, and total nitrogen.

1.3 These test methods can be used to provide for the requirements specified in Practice D 3176 for the ultimate analysis.

1.4 The values stated in SI units shall be regarded as the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in 8.3.1.