Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Practice for Determination of 2 % Secant Modulus for Polyethylene Geomembranes
Automaticky preložený názov:
Štandardná prax pre stanovenie 2% sečného modulu pre polyetylén Geomembranes
NORMA vydaná dňa 1.6.2011
Označenie normy: ASTM D5323-92(2011)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.6.2011
Kód tovaru: NS-30734
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
geomembranes, secant modulus, polyethylene, Geomembranes, Plastic sheet and film--specifications, Polyethylene (PE) geomembrane applications, Polyethylene (PE) sheet and film--specifications, Secant modulus, ICS Number Code 59.080.70 (Geotextiles)
Significance and Use | ||
Where to draw the tangent to determine the modulus of elasticity is often unclear when performing tensile tests with polyethylene geomembranes. This problem results in a wide variation in test results and therefore makes this property unreliable for comparisons. A secant modulus based on 2 % strain can be useful when making comparisons between materials, in quality control, and in comparing the same sample after being subjected to a nonstandard environment. Secant modulus is an approximation of modulus of elasticity and generally results in a lower value than that for the modulus of elasticity. Although the technique for measuring 2 % secant modulus is described here, other percent secant moduli can be measured by this practice. |
||
1. Scope | ||
1.1 This practice presents a technique for calculating the 2 % secant modulus for polyethylene geomembranes between 0.5 and 5 mm (20 and 200 mil) using Test Method D638. 1.2 This practice will facilitate modulus comparisons of similar materials by standardizing the method for deriving the points on the stress-strain curve from which the calculations are performed. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
2. Referenced Documents | ||
|
Historická
1.10.2011
Historická
1.3.2010
Historická
1.1.2013
Historická
1.6.2011
Historická
15.2.2012
Historická
1.7.2012
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.