Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D5275-20
Standard Test Method for Fuel Injector Shear Stability Test (FISST) for Polymer Containing Fluids
NORMA vydaná dňa 1.5.2020
Informácie o norme:
Označenie normy: ASTM D5275-20
Dátum vydania normy: 1.5.2020
Kód tovaru: NS-993160
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM D5275-20 :
Keywords:
VII, fuel injector, polymer containing fluids, shear stability,, ICS Number Code 43.060.40 (Fuel systems)
Doplňujúce informácie
| Significance and Use | ||||||
|
4.1 This test method evaluates the percent viscosity loss for polymer-containing fluids resulting from polymer degradation in the high shear nozzle device. Minimum interference from thermal or oxidative effects are anticipated. 4.2 This test method is not intended to predict viscosity loss in field service for different polymer classes or for different field equipment. Some correlation for a specific polymer type in specific field equipment can be possible. |
||||||
| 1. Scope | ||||||
|
1.1 This test method covers the measurement of the percent viscosity loss at 100 °C of polymer-containing fluids using fuel injector shear stability test (FISST) equipment. The viscosity loss reflects polymer degradation due to shear at the nozzle. Note 1: Test Method D2603 has been used for similar
evaluation of this property. It has many of the same limitations as
indicated in the significance statement. No detailed attempt has
been undertaken to correlate the results by the sonic and the
diesel injector methods.
Note 2: This test method was originally published as Procedure
B of Test Methods D3945. The
FISST method was made a separate test method after tests of a
series of polymer-containing fluids showed that Procedures A and B
of Test Methods D3945 often
give different results.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.2.1 Exception—PSI is mentioned in parentheses for instruments that have only PSI gauges. Horsepower, HP, is listed in parentheses since the motor labels display this value. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||
| 2. Referenced Documents | ||||||
|
Odporúčame:
Aktualizácia technických noriem
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
