Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Fuel Injector Shear Stability Test (FISST) for Polymer Containing Fluids
Automaticky preložený názov:
Štandardná skúšobná metóda pre vstrekovače paliva strihová stabilita Test (FISST) pre polymér obsahujúci tekutín
NORMA vydaná dňa 1.5.2011
Označenie normy: ASTM D5275-11
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2011
Kód tovaru: NS-30549
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
VII, fuel injector, polymer containing fluids, shear stability, Viscosity--petroleum products, Polymer-containing fluids, Shear testing--petroleum products, Fuel injector shear stability test (FISST), ICS Number Code 43.060.40 (Fuel systems)
Significance and Use | ||||||
This test method evaluates the percent viscosity loss for polymer-containing fluids resulting from polymer degradation in the high shear nozzle device. Minimum interference from thermal or oxidative effects are anticipated. This test method is not intended to predict viscosity loss in field service for different polymer classes or for different field equipment. Some correlation for a specific polymer type in specific field equipment can be possible. |
||||||
1. Scope | ||||||
1.1 This test method covers the measurement of the percent viscosity loss at 100°C of polymer-containing fluids using fuel injector shear stability test (FISST) equipment. The viscosity loss reflects polymer degradation due to shear at the nozzle. Note 1—Test Method D2603 has been used for similar evaluation of this property. It has many of the same limitations as indicated in the significance statement. No detailed attempt has been undertaken to correlate the results by the sonic and the diesel injector methods. Note 2—This test method was originally published as Procedure B of Test Methods . The FISST method was made a separate test method after tests of a series of polymer-containing fluids showed that Procedures A and B of Test Methods often give different results. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.2.1 Exception—PSI is mentioned in parentheses for instruments that have only PSI gauges. Horsepower, HP, is listed in parentheses since the motor labels display this value. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 7. |
||||||
2. Referenced Documents | ||||||
|
Historická
1.11.2012
Historická
1.5.2013
Historická
1.10.2013
Historická
1.7.2014
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.