Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D5266-99(2005)
Standard Practice for Estimating the Percentage of Wood Failure in Adhesive Bonded Joints
Automaticky preložený názov:
Štandardná prax pre odhad podiel drevených zlyhania u lepeného spoja
NORMA vydaná dňa 1.4.2005
Informácie o norme:
Označenie normy: ASTM D5266-99(2005)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.4.2005
Kód tovaru: NS-30517
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM D5266-99(2005) :
Keywords:
adhesive, finger joints, parallel laminates, plywood, wood failure, ICS Number Code 83.180 (Adhesives)
Doplňujúce informácie
| Significance and Use | ||||||||||||||||||||||||||
|
Wood failure is one of the principal means for determining the quality of an adhesively bonded wood joint. When evaluated after a water soaking, water soaking and drying, or boiling and drying, the percentage of wood failure is an important criterion for qualifying adhesives for use in plywood and glued laminated structural timber for exterior use, and for daily quality control of the processes for manufacturing plywood and glued, laminated timbers. Standards that use the percentage of wood failure are included in Section 2. In plywood manufactured from North American softwood species, the percentage of wood failure of Test Method D 906 specimens, tested wet after either a vacuum-pressure soak-dry or boil-dry treatment, correlates with the percentage of panels that delaminate in outdoor exposure without protection.8 Similar correlations for other products have not been published. |
||||||||||||||||||||||||||
| 1. Scope | ||||||||||||||||||||||||||
|
1.1 This practice provides procedures for estimating the percentage of wood failure that occurs in plywood-shear, block-shear, finger joint test specimens, or any other bondline involving wood. 1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are provided for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||
|
Doporučujeme:
