Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Guide for Establishing a Program for Condition Assessment of Coating Service Level I Coating Systems in Nuclear Power Plants
Automaticky preložený názov:
Štandardné Sprievodca pre vytvorenie programu pre hodnotenie stavu náterových služieb Level I náterových systémov v jadrových elektrárňach
NORMA vydaná dňa 1.11.2008
Označenie normy: ASTM D5163-08
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.11.2008
Kód tovaru: NS-30093
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
coating performance, coatings monitoring program, inspection, maintenance, nuclear power plant, Service Level I coatings, surveillance, Inspection--coating applications, Nuclear reactor vessels--coatings applications, Performance--nuclear materials/applications, Performance--paints/coatings/related applications, Safety precautions--coating applications, Coatings monitoring program, Maintenance coatings, Surveillance, ICS Number Code 27.120.20 (Nuclear power plants. Safety)
Significance and Use | ||||||||||||||||||||
Establishment of an in-service coatings monitoring program permits planning and prioritization of coatings maintenance work as needed to maintain coating integrity and performance in nuclear Coating Service Level I coating systems. For additional information on nuclear maintenance coating work, refer to ASTM Manual on Maintenance Coatings for Nuclear Power Plants. A coatings monitoring program enables early identification and detection of potential problems in coating systems. Some Coating Service Level I coating systems may be known in advance to be suspect, deficient, or unqualified. Monitoring coating performance will assist in developing follow-up procedures to resolve any significant deficiency relative to coating work. Degraded coatings may generate debris under design basis accident conditions that could adversely affect the performance of the post-accident safety systems. A coatings monitoring program may be required to fulfill safety analysis report and generic letter commitments for Coating Service Level I coating work in a nuclear power plant facility. |
||||||||||||||||||||
1. Scope | ||||||||||||||||||||
1.1 This standard covers procedures for establishing a monitoring program for condition assessment of Coating Service Level I coating systems in operating nuclear power plants. Monitoring is an ongoing process of evaluating the condition and performance of the in-service coating systems. 1.2 It is the intent of this standard to provide a recommended basis for establishing a coatings condition assessment program, not to mandate a singular basis for all programs. Variations or simplifications of the program described in this standard may be appropriate for each operating nuclear power plant depending on their licensing commitments. Similar guidelines are applicable for Coating Service Level III and other areas outside containment. 1.3 This standard does not address the requirements of ASME Section XI, In-Service Inspection Subsections IWE and IWL. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||
|
Historická
1.11.2008
Historická
1.1.2013
Historická
1.10.2010
Historická
1.10.2010
Historická
1.6.2009
Historická
1.10.2010
Posledná aktualizácia: 2024-08-30 (Počet položiek: 2 345 304)
© Copyright 2024 NORMSERVIS s.r.o.