Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Analysis of Styrene by Capillary Gas Chromatography
NORMA vydaná dňa 1.1.2021
Označenie normy: ASTM D5135-21
Dátum vydania normy: 1.1.2021
Kód tovaru: NS-1017145
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
analysis by gas chromatography, impurities in styrene, purity of styrene, styrene, styrene monomer,, ICS Number Code 71.080.15 (Aromatic hydrocarbons)
Significance and Use | ||||||||||||||||
5.1?This test method is designed to obtain styrene purity on the basis of impurities normally present in styrene and may be used for final product inspections and process control. 5.2?This test method will detect the impurities shown in Table 1, non-aromatic hydrocarbons containing ten carbons or less, and others where specific impurity standards are available. Absolute purity cannot be determined if unknown impurities are present. |
||||||||||||||||
1. Scope | ||||||||||||||||
1.1?This test method covers the determination of the impurities typically found in styrene and uses those values to determine the purity of styrene by difference by gas chromatography. Typical impurities in commercial styrene are found in Table 1. 1.2?This test method is applicable to impurity concentrations up to 1 %. 1.2.1?The limit of detection is 0.0003 mass % and the limit of quantitation is 0.0010 mass %. 1.2.2?LOD and LOQ were calculated using data from ILS results for n-propylbenzene in Table 3. 1.3?In determining the conformance of the test results using this method to applicable specifications, results shall be rounded off in accordance with the rounding-off method of Practice E29. 1.4?The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5?This standard does not purport to address all the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||
2. Referenced Documents | ||||||||||||||||
|
Posledná aktualizácia: 2024-11-03 (Počet položiek: 2 209 203)
© Copyright 2024 NORMSERVIS s.r.o.