Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Determination of Chloride, Nitrate, and Sulfate in Atmospheric Wet Deposition by Chemically Suppressed Ion Chromatography
Automaticky preložený názov:
Štandardná skúšobná metóda pre stanovenie chloridu, dusičnanu a síran atmosférického mokrej depozície chemicky vypnutý iónovou chromatografiou
NORMA vydaná dňa 1.10.2013
Označenie normy: ASTM D5085-02(2013)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.10.2013
Kód tovaru: NS-29777
Počet strán: 9
Približná hmotnosť: 27 g (0.06 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
atmospheric wet deposition samples, chloride, ion chromatography, nitrate, sulfate, ICS Number Code 07.060 (Geology. Meteorology. Hydrology),71.040.40 (Chemical analysis)
Significance and Use | ||||||||||||||||||||||
5.1 This test method is useful for the determination of the anions: chloride, nitrate, and sulfate in atmospheric wet deposition. 5.2 Fig. X1.1 in the appendix represents cumulative frequency percentile concentration plots of chloride, nitrate, and sulfate obtained from analyses of over 5000 wet deposition samples. These data may be used as an aid in the selection of appropriate calibration solutions. (3) |
||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||
1.1 This test method is applicable to the determination of chloride, nitrate, and sulfate in atmospheric wet deposition (rain, snow, sleet, and hail) by chemically suppressed ion chromatography (1)2. For additional applications refer to Test Method D4327. 1.2 The concentration ranges for this test method are listed below. The range tested was confirmed using the interlaboratory collaborative test (see Table 1 for statistical summary of the collaborative test). 1.3 The method detection limit (MDL) is based on single operator precision (2) and may be higher or lower for other operators and laboratories. The precision and bias data presented are insufficient to justify use at this low level, however, many workers have found that this test method is reliable at lower levels than those that were tested. 1.4 This standard does not
purport to address all of the safety concerns, if any, associated
with its use. It is the responsibility of the user of this standard
to establish appropriate safety and health practices and determine
the applicability of regulatory limitations prior to use.
Standard Practice for Preparation of
Materials Used for the Collection and Preservation of Atmospheric
Wet Deposition IEEE/ASTM SI-10 Standard for Use of the International
System of Units (SI): The Modern Metric System Standard Practice for Intralaboratory
Quality Control Procedures and a Discussion on Reporting Low-Level
Data (Withdrawn 2002) Standard Test Method for Anions in Water
by Suppressed Ion Chromatography Standard Specification for Laboratory
Glass Volumetric Apparatus Standard Terminology Relating to Sampling
and Analysis of Atmospheres (Includes all amendments and changes
9/7/2020). Standard Practice for Determination of
Precision and Bias of Applicable Test Methods of Committee D19 on
Water Standard Guide for Determination of
Precision and Bias of Methods of Committee D22 Standard Terminology Relating to
Plastics Standard Terminology Relating to Water
(Includes all amendments and changes 2/14/2024). Standard Specification for Reagent
Water |
Historická
1.10.2012
Historická
1.2.2012
Historická
1.5.2014
Historická
15.6.2012
Historická
1.3.2008
Historická
1.10.2013
Posledná aktualizácia: 2024-11-03 (Počet položiek: 2 209 203)
© Copyright 2024 NORMSERVIS s.r.o.