Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Estimating the Organic Fouling of Particulate Anion Exchange Resins (Withdrawn 2018)
Automaticky preložený názov:
Štandardná skúšobná metóda pre odhad Organic zanášanie častíc anexu
NORMA vydaná dňa 1.5.2009
Označenie normy: ASTM D5042-90(2009)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2009
Kód tovaru: NS-29610
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
anion resin, organic carbon, organic fouling, Contamination--water, Ion exchange resins, Organic compounds--water, ICS Number Code 71.100.40 (Surface active agents)
Significance and Use | ||||||||||||
One of the major factors in the unsatisfactory performance of anion exchange resins is their fouling by organic material. Knowledge of the degree of fouling can be used to assess the condition of the resin and may indicate the need for pretreatment of the influent, remedial cleaning procedures, or resin replacement. It is recognized that this test method may not remove and detect cation sloughage products or declumping agents. It is not intended to remove all organic compounds from the resin. Since the chemical structures of organics compounds fouling the resin are generally unknown and are expressed only on the basis of their carbon content, interpretation of test results to form a basis for predictions for resin performance or cleaning procedures should be approached with caution. Samples may be taken before or after plant regeneration, or both, depending on the type of information desired. This decision is left to the judgment of the user. |
||||||||||||
1. Scope | ||||||||||||
1.1 This test method provides a general estimate of the organic fouling of an anion exchange resin based upon total organic carbon measurements. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see 8.3. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Historická
1.1.2014
Historická
1.10.2009
Historická
1.1.2014
Historická
1.10.2009
Historická
1.10.2009
Historická
1.5.2009
Posledná aktualizácia: 2024-05-16 (Počet položiek: 2 902 054)
© Copyright 2024 NORMSERVIS s.r.o.