Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Practices for Calibration of Ozone Monitors Using Transfer Standards
NORMA vydaná dňa 1.10.2017
Označenie normy: ASTM D5011-17
Dátum vydania normy: 1.10.2017
Kód tovaru: NS-799291
Počet strán: 29
Približná hmotnosť: 87 g (0.19 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
boric acid titration, gas phase titration, ozone, primary standard, transfer standard,, ICS Number Code 13.040.01 (Air quality in general)
Significance and Use | ||||||||||||||||||
5.1 The reactivity and instability of O5.2 The primary UV standard photometers, which are usually used at a fixed location under controlled conditions, are used to certify transfer standards that are then transported to the field sites where the ambient ozone monitors are being used. See Practice D5110. 5.3 The advantages of this procedure are: 5.3.1 All O3 monitors in a given network or region may be traced to a single primary standard. 5.3.2 The primary standard is used at only one location, under controlled conditions. 5.3.3 Transfer standards are more rugged and more easily portable than primary standards. 5.3.4 Transfer standards may be used to intercompare various primary standards. |
||||||||||||||||||
1. Scope | ||||||||||||||||||
1.1 These practices describe means for calibrating ambient, workplace or indoor ozone monitors, using transfer standards. 1.2 These practices describe five types of transfer standards: Practice A—Analytical instruments, Practice B—Boric acid potassium iodide (BAKI) manual analytical procedure, Practice C—Gas phase titration with excess nitric oxide, Practice D—Gas phase titration with excess ozone, and Practice E—Ozone generator device. 1.3 These practices describe procedures to establish the authority of transfer standards: qualification, certification, and periodic recertification. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||
|
Poskytovanie aktuálnych informácií o legislatívnych predpisoch vyhlásených v Zbierke zákonov od roku 1945.
Aktualizácia 2x v mesiaci !
Chcete vedieť viac informácii ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-11-21 (Počet položiek: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.