Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Index Puncture Resistance of Geomembranes and Related Products
Automaticky preložený názov:
Štandardná skúšobná metóda pre index pevnosť proti prerazeniu Geomembranes a súvisiacich výrobkov
NORMA vydaná dňa 1.12.2007
Označenie normy: ASTM D4833-07
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.12.2007
Kód tovaru: NS-28813
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
geomembranes, puncture, puncture resistance, Geomembranes, Geosynthetics, Index puncture resistance, Puncture testing, ICS Number Code 59.080.70 (Geotextiles)
Significance and Use | ||||||||||||||
This test method is an index test for determining the puncture resistance of geomembranes and related products. The use of this test method is to establish an index value by providing standard criteria and a basis for uniform reporting. This test method is considered satisfactory for acceptance testing of commercial shipments of geomembranes and related materials since the test method has been used extensively in the trade for acceptance testing. In case of a dispute arising from differences in reported test results when using this test method for acceptance testing of commercial shipments, the purchaser and the supplier should conduct comparative tests to determine if there is a statistical bias between their laboratories. Competent statistical assistance is recommended for the investigation of bias. As a minimum, the two parties should take a group of test specimens that are as homogeneous as possible and that are from a lot material of the type in question. The test specimens should then be randomly assigned in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared using Student's t-test for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun. If a bias is found, either its cause must be found and corrected or the purchaser and the supplier must agree to interpret future test results in the light of the known bias. |
||||||||||||||
1. Scope | ||||||||||||||
1.1 This test method is used to measure the index puncture resistance of geomembranes and related products. 1.2 The use of Test Method D 4833 may be inappropriate for testing some woven geotextiles or related products which have large openings, such as geonets and geogrids. 1.3 It is recommended that geotextile and geotextile related products be tested using Test Method D6241. 1.4 The values stated in SI units are to be regarded as the standard. The values provided in inch-pound units are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.