Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Ash from Petroleum Products
NORMA vydaná dňa 1.11.2019
Označenie normy: ASTM D482-19
Dátum vydania normy: 1.11.2019
Kód tovaru: NS-978001
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
ash, crude oils, distillate oils, fuel oils, lubricating oils,, ICS Number Code 75.080 (Petroleum products in general)
Significance and Use | ||||||||||||
4.1 Knowledge of the amount of ash-forming material present in a product can provide information as to whether or not the product is suitable for use in a given application. Ash can result from oil or water-soluble metallic compounds or from extraneous solids such as dirt and rust. |
||||||||||||
1. Scope | ||||||||||||
1.1 This test method covers the determination of ash in the range 0.010 % to 0.180 % by mass, from distillate and residual fuels, gas turbine fuels, crude oils, lubricating oils, waxes, and other petroleum products, in which any ash-forming materials present are normally considered to be undesirable impurities or contaminants (Note 1). The test method is limited to petroleum products which are free from added ash-forming additives, including certain phosphorus compounds (Note 2). Note 1: In certain types of samples, all of the ash-forming
metals are not retained quantitatively in the ash. This is
particularly true of distillate oils, which require a special ash
procedure in order to retain metals quantitatively.
Note 2: This test method is not intended for the analysis of
unused lubricating oils containing additives; for such samples use
Test Method D874. Neither is
it intended for the analysis of lubricating oils containing lead
nor for used engine crankcase oils.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. The preferred expression of the property is mass %. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.