Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Methods for Nonvolatile Content of Heatset and Liquid Printing Ink Systems
NORMA vydaná dňa 1.6.2020
Označenie normy: ASTM D4713-12(2020)
Dátum vydania normy: 1.6.2020
Kód tovaru: NS-997829
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
heatset-type printing inks, liquid printing ink, nonvolatile matter content, ovens, printing inks, resin solutions, solvents, vehicles,, ICS Number Code 87.080 (Inks. Printing inks)
Significance and Use | ||||||||||
4.1 Nonvolatile content of printing inks is useful for specification acceptance between the producer and the user. 4.2 In order to obtain accurate results for heatset systems within the specified 3-h heating time, the specimen film thickness must be less than 100 g/m2, and the oven must have forced ventilation. Thickness of the specimen film is less critical for liquid ink systems. |
||||||||||
1. Scope | ||||||||||
1.1 These test methods cover the determination of weight content of nonvolatile matter in two types of printing inks. 1.2 Test Method A is applicable to heatset-type printing inks and resin solutions; solvents in such systems typically have initial boiling points in the range from 240 to 275°C (470 to 535°F) and vapor pressures less than 0.2 mm Hg. 1.3 Test Method B is applicable to liquid-type printing inks and vehicles based on aqueous or organic solvents that evaporate readily at ordinary room temperatures. Note 1: Test Method A (for heatset systems) specifies a
specimen film thickness that is much thinner than those produced by
related test methods; one exception is Test Method B in Test
Methods D1259, which is
recommended as a referee test.
Note 2: Test Method B (for liquid ink systems) is similar to
Test Method D2369 except that
a solvent is not required for spreading the test
specimen.
1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
2. Referenced Documents | ||||||||||
|
Posledná aktualizácia: 2024-11-29 (Počet položiek: 2 209 895)
© Copyright 2024 NORMSERVIS s.r.o.