Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Evaluating the Effective Surface Area of Zinc Oxide in Rubber
Automaticky preložený názov:
Štandardná skúšobná metóda pre hodnotenie na účinnú plochu oxidu zinočnatého v kaučuku
NORMA vydaná dňa 1.5.2012
Označenie normy: ASTM D4620-02(2012)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2012
Kód tovaru: NS-27921
Počet strán: 2
Približná hmotnosť: 6 g (0.01 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
curemeter, surface area, zinc oxide, ICS Number Code 83.060 (Rubber)
Significance and Use | ||||||||
The surface area of zinc-oxide in rubber can significantly affect cure activation and vulcanizate properties. The specific surface area of zinc-oxide is usually measured by nitrogen absorption which requires the use of equipment not normally found in rubber laboratories. This test method allows a ranking of zinc-oxide samples according to their surface areas with respect to a known standard using a simplified procedure involving mixing of rubber compounds and measuring cure times with oscillating disk or rotorless cure meters. This test method may be used for quality control, research and development work, and comparison of different zinc-oxide samples. |
||||||||
1. Scope | ||||||||
1.1 This test method specifies the standard materials, mixing procedure, and test method for ranking zinc-oxide samples according to their specific surface area in a standard test formula based on chloroprene rubber (CR). 1.2 The ranking is based on the cure time of the standard CR formulation. 1.3 The accurate surface area cannot be determined by this test method, since factors other than surface area may influence the cure times to some extent (for example acidity, heavy metal traces, etc.). 1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||
2. Referenced Documents | ||||||||
|
Historická
1.5.2011
Historická
1.1.2009
Historická
1.5.2014
Historická
1.1.2012
Historická
1.7.2009
Historická
1.1.2009
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.