Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Volatile Matter in Silicone Fluid
Automaticky preložený názov:
Štandardná skúšobná metóda pre prchavých látok v silikónová kvapalina
NORMA vydaná dňa 1.5.2010
Označenie normy: ASTM D4559-99(2010)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2010
Kód tovaru: NS-27699
Počet strán: 2
Približná hmotnosť: 6 g (0.01 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
insulating liquid, silicone, volaticity, Contamination--insulation materials/applications, Electrical insulating liquids, Hydraulic fluids/oils, Organic chemicals, Plastic sheet and film, Silicone--oils/fluids, Volatile matter content, ICS Number Code 75.100 (Lubricants, industrial oils and related products)
Significance and Use | ||||
High values may indicate contamination of the silicone with other materials, inadequate removal of volatile components by the producer, or the presence of a depolymerization catalyst. The outcome will be affected directly by the presence of any high vapor pressure material in the sample, such as solvents or low molecular weight silicones. A high volatile content could also indicate the presence of a depolymerization catalyst in the fluid. The time and temperature specified in this test method are ideal for detecting the effect of such a material, as the depolymerization takes place at a highly accelerated rate and the low molecular weight components are rapidly evaporated. The result is a very significant weight loss during the test period. The exact amount depends on the type and amount of catalyst present. The conditions specified in the method should not cause measureable depolymerization of silicone if such a catalyst is not present. |
||||
1. Scope | ||||
1.1 This test method describes a procedure for determining the volatile matter in silicone fluids used for electrical insulation. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Historická
15.6.2013
Historická
1.5.2010
Historická
1.10.2011
Historická
1.10.2013
Historická
1.5.2010
Historická
1.12.2012
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.