Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Methods for Nonmetallic Semi-Conducting and Electrically Insulating Rubber Tapes
NORMA vydaná dňa 1.8.2020
Označenie normy: ASTM D4325-20
Dátum vydania normy: 1.8.2020
Kód tovaru: NS-1004053
Počet strán: 7
Približná hmotnosť: 21 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
dielectric strength, dissipation factor, elongation, fusion, heat exposure, ozone resistance, permittivity, rubber electrical insulating tape, rubber semi-conducting nonmetallic tape, tensile strength, ultraviolet and weather exposure, volume resistivity ,, ICS Number Code 29.035.20 (Plastic and rubber insulating materials)
Significance and Use | ||||||||||||||||||||||||||||||
5.1 The physical and electrical properties, including break strength, elongation, dielectric strength, dissipation factor, permittivity, fusion, etc., will vary with temperature and moisture content. Control the temperature and moisture content of the sample for these test methods to yield consistent and reproducible results. |
||||||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||||||
1.1 These test methods cover the methods and procedures for testing electrically insulating and semi-conducting rubber tapes designed for splicing, terminating, and sheath repair of electrical wire and cable. 1.2 The test methods appear in the following sections:
1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard. Note 1: There is no IEC equivalent to these
methods.
1.4 Unless otherwise stated, measurements are made on tapes from which the removable separator has been removed. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||
|
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.