Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Contact-Molded Glass-Fiber-Reinforced Thermoset Resin Corrosion-Resistant Tanks
Automaticky preložený názov:
Štandard Specification pre Contact-lisovaného skla, z vystužených termosetickou živicou odolné proti korózii nádrže
NORMA vydaná dňa 1.1.2010
Označenie normy: ASTM D4097-01(2010)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.1.2010
Kód tovaru: NS-26018
Počet strán: 16
Približná hmotnosť: 48 g (0.11 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
above ground, atmosphere, contact-molded, polyester, vinylester, Aboveground storage tanks, Chemical resistance--plastics, Chemical-resistant nonmetallic materials, Containers--tanks, Corrosive service applications--plastics, Cylindrical tanks, Glass-fiber-reinforced (GRP) plastics--specifications, Installation--plastic pipe materials/applications, Joint construction, Laminates--plastic, Liquid environments, Outdoor service equipment, Plastics--glass-fiber reinforced products
1. Scope | ||||||||||||||||||||||||||||||||
1.1 This specification covers cylindrical tanks fabricated by contact molding for above-ground vertical installation, to contain aggressive chemicals at essentially atmospheric pressure, and made of a commercial-grade polyester or vinyl ester, resin. Included are requirements for materials, properties, design, construction, dimensions, tolerances, workmanship, and appearance. 1.2 This specification does not cover the design of vessels intended for pressure above hydrostatic, vacuum conditions, except as classified herein, or vessels intended for use with liquids heated above their flash points. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are provided for information purposes only. Note 1—Special design consideration should be given to vessels subject to superimposed mechanical forces, such as earthquakes, wind load, or agitation, to vessels subject to service temperature in excess of 180°F (82°C), and to vessels with unsupported bottoms. Note 2—There is no known ISO equivalent to this standard. 1.4 The following safety hazards caveat pertains only to the test method portion, Section 11, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||
|
Historická
1.10.2013
Historická
1.4.2010
Historická
1.4.2013
Historická
1.7.2011
Historická
15.6.2012
Historická
15.6.2012
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.