Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D4033-92
Standard Test Method for Resistance to Yarn Slippage at the Sewn Seam in Upholstery Fabrics (Dynamic Fatigue Method) (Withdrawn 2001)
Automaticky preložený názov:
Štandardná skúšobná metóda pre odolnosť proti priadze preklzávania na šitý šev v poťahových látok ( Dynamic Únava metóda ) ( Withdrawn 2001 )
NORMA vydaná dňa 1.1.1992
Informácie o norme:
Označenie normy: ASTM D4033-92
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.1.1992
Kód tovaru: NS-25796
Počet strán: 7
Približná hmotnosť: 21 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM D4033-92 :
Keywords:
Acceptance criteria/testing-textile fabr/fibers, Impact testing, Impact testing-textile materials/applications, Loading tests-textiles, Sewn seams, Upholstery fabr/materials, Yarn slippage, yarn slippage-sewn seams (from upholstery fabr), by dynamic fatigue, method, test,, Dynamic fatigue method, yarn slippage-sewn seams (from upholstery fabr), test,, Resistance-yarn slippage, sewn seams-upholstery fabr, by dynamic fatigue method, test, ICS Number Code 59.080.30 (Textile fabr)
Doplňujúce informácie
| 1. Scope |
|
1.1 This test method covers the measurement of or visual evaluation of yarn slippage and other types of failures in the three most commonly used upholstery seams-warp sewn to warp (wale to wale), filling sewn to filling (course to course), and warp sewn to filling (wale to course). The stresses at the seam are created by imposing a cyclic, impact, and penetrating load which fatigues the seam construction. Note 1-Within this test method it is assumed, for simplicity, that the sample being tested is of a woven construction. In case the sample is of a knot construction, it is only necessary to substitute "wale" for "warp" and "course" for "filling" in the instructions.1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
Doporučujeme:
