Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D3929-03(2010)e1
Standard Test Method for Evaluating Stress Cracking of Plastics by Adhesives Using the Bent-Beam Method (Includes all amendments And changes 9/7/2015).
Automaticky preložený názov:
Štandardná skúšobná metóda pre hodnotenie napätia dôjsť k praskaniu plastov lepidiel s použitím Bent-Beam Metóda
NORMA vydaná dňa 1.4.2010
Informácie o norme:
Označenie normy: ASTM D3929-03(2010)e1
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.4.2010
Kód tovaru: NS-25369
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM D3929-03(2010)e1 :
Keywords:
adhesive compatibility, bent-beam, cracking, crazing, liquid adhesive, stress cracking, Tensile properties/testing--adhesive bonds, Stress cracking tests, Adhesive-bonded plastics, Adhesive compatibility, Adhesives, Bend testing, Bent-beam method, Compatibility, Crazing, Deflection, Liquid adhesives, Loading tests--adhesives, Stress--adhesives, ICS Number Code 83.080.01 (Plastics in general), 83.180 (Adhesives)
Doplňujúce informácie
| Significance and Use | ||||||
|
This test method is designed for obtaining a qualitative estimate of the compatibility of plastics and adhesives. Due to the many process variables associated with the fabrication of plastic parts, it is not possible to use this test as a substitute for compatibility tests on actual parts. The detection of cracks or crazes may be determined with or without optical aid. Make comparisons only among tests employing crack detection methods of equivalent sensitivity. |
||||||
| 1. Scope | ||||||
|
1.1 This test method describes a procedure for determining the compatibility of adhesives with plastics based on whether the adhesive causes cracking of stressed samples. 1.2 Specimen configurations and test fixture designs are given. 1.3 This test method is suitable for products in the form of sheet or strip. It can also be used on injection molded tensile specimens or flexural bars. 1.4 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||
| 2. Referenced Documents | ||||||
|
Odporúčame:
Aktualizácia zákonov
Chcete mať istotu o platnosti využívaných predpisov?
Ponúkame Vám riešenie, aby ste mohli používať stále platné (aktuálne) legislatívne predpisy
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
