Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D3917-96(2002)e1
Standard Specification for Dimensional Tolerance of Thermosetting Glass-Reinforced Plastic Pultruded Shapes (Includes all amendments And changes 12/31/2010).
Automaticky preložený názov:
Štandardné špecifikácie pre Tolerancia rozmerov Teplom Sklolaminát ťahané Shapes
NORMA vydaná dňa 10.11.1996
Informácie o norme:
Označenie normy: ASTM D3917-96(2002)e1
Poznámka: NEPLATNÁ
Dátum vydania normy: 10.11.1996
Kód tovaru: NS-25335
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM D3917-96(2002)e1 :
Keywords:
dimensional tolerance, pultruded shapes, thermosetting plastic, ICS Number Code 83.140.20 (Laminated sheets)
Doplňujúce informácie
| 1. Scope |
|
1.1 This specification defines tolerances applicable to standard rods, bars, and shapes pultruded from thermosetting glass-reinforced plastics. 1.2 These dimensional tolerances apply to all shapes specified as "standard" by the pultrusion industry. 1.3 Custom shapes and products designed for special applications shall carry specific tolerances that may vary from the standard because a change in type or amount of reinforcement used in a composite directly affects dimensions. The tolerances may be wider or closer than associated with "standard" shapes. 1.4 The following safety hazards caveat pertains only to the test methods portion, Section 4 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note—There is no similar or equivalent ISO standard. |
Doporučujeme:
