Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Rapid Thermal Degradation of Solid Electrical Insulating Materials By Thermogravimetric Method (TGA)
Automaticky preložený názov:
Štandardná skúšobná metóda pre rýchle tepelnej degradácie Solid elektrických izolačných materiálov termogravimetrického metódou (TGA)
NORMA vydaná dňa 1.1.2012
Označenie normy: ASTM D3850-12
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.1.2012
Kód tovaru: NS-25091
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
degradation, insulating, mass loss, polymeric material, thermogravimetric analysis, TGA , Heating tests--electrical insulating materials, Mass loss testing, Degradation, Electrical insulating plastics, Polymers (electrical insulation applications), Rapid thermal degradation, Thermal analysis (TA)--electrical insulation, Thermal endurance--electrical insulating materials, Thermogravimetric analysis (TGA), ICS Number Code 29.035.01 (Insulating materials in general)
Significance and Use | ||||||||||||||
Thermogravimetry is useful in determining the dynamic functional effect of temperature on the amount of volatile materials leaving a specimen as the latter is heated progressively to higher temperatures. TGA can be useful for process control, process development, material evaluation, and for identification and quality control in specifications. The thermal stability of a material can be associated with the degree and time rate of mass loss as a function of temperature. TGA curves can, therefore, be used as a preliminary screen method in the evaluation of relative behavior of insulating materials of the same generic family. The functional temperature-life relationship of an insulating material in any given application depends on a number of service and environmental factors. Therefore, the information obtained from TGA curves is not adequate by itself to describe the thermal capability of an insulating material. Refer to the Appendix for further discussion of the interpretation of TGA data. |
||||||||||||||
1. Scope | ||||||||||||||
1.1 This test method outlines a procedure for obtaining thermogravimetric (TGA) data on solid polymeric materials intended for use as electrical insulating materials. 1.2 Do not use this standard to quantify an estimate of the long-term thermal capability for any electrical insulating material. If a relationship exists between TGA and the long-term thermal capabilities of a material, then that fact must be established and made public, preferably by comparing data between a candidate and another material known to display similar failure modes. 1.3 The values stated in SI units are the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Historická
1.11.2012
Historická
1.3.2013
Historická
1.1.2012
Historická
1.11.2013
Historická
15.5.2014
Historická
1.10.2010
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.